The atom chip used to control the atoms.
Credit: TU Wien
For a long time, quantum experiments were
only carried out with a small number of particles. Even the behaviour of
single atoms or molecules can be very hard to describe. Today, it has
become possible to control several thousand atoms in an experiment, but
for theoretical calculations this entails serious problems. The quantum
state of such a large system is so complicated that all matter on earth
would not be enough to store it in a classical way.
In the journal Nature Communications, scientists from the TU
Wien (Vienna) and the Free University of Berlin now present a quantum
tomography method, which makes it possible to measure and describe the
state of a large quantum system very precisely with just a few
measurements. The basic idea behind this new technique is simple: even
though the system can be in one of unimaginably many quantum states, it
is a very good approximation to ignore most of them.
Many Particles, Many States
The result of a coin toss is either heads or tails. The behaviour of
quantum particles, however, is much more complicated. When a quantum
system can be in two different states, any mixture of these states is
also a physically allowed state. Therefore it is much more complicated
to describe the state of a quantum particle than it is to describe the
state of a coin lying on the table.
"The larger the number of particles, the more complicated the
description of the systems becomes," says Professor Jörg Schmiedmayer
from the Vienna Center for Quantum Science and Technology (VCQ) at TU
Wien. "The storage capacity required to describe a quantum state grows
exponentially with the number of particles. For a system of several
hundred quantum particles, there are more possible quantum states than
there are atoms in the universe. It is absolutely impossible to write
down such a state or to do calculations with it."
But exactly knowing the quantum state is not always necessary. The
new theoretical method, developed in Berlin by Professor Jens Eisert's
research group, uses a special kind of description for the quantum
states -- the so called "continuous matrix product states" (cMPS). This
special class of states only represents a vanishingly small fraction of
all possible states, but from a physical point of view they are
particularly important. "This class contains states with realistic
quantum entanglement," says Jens Eisert. "Exotic, complicated
entanglement patterns between many quantum particles may in principle be
possible, but in practice they do not show up in physical systems. That
is why we can limit ourselves to the cMPS in our calculations."
For any possible quantum state, there is a cMPS arbitrarily close to
the true quantum state. No matter which state is really occupied by the
system -- the error that occurs by only taking into account the cMPS can
be made arbitrarily small. "It is like fractions in mathematics," says
Eisert. "The rational numbers, which can be written as fractions, only
represent a tiny part of all real numbers. But for any real number, a
fractional number can be found which comes arbitrarily close." The
number pi is not a fractional number -- but the approximation for pi
used by a pocket calculator is. For all practical purposes, this is good
enough.
Measurements Yielding a Quantum Picture
By restricting oneself to the cMPS, it becomes possible to read out
the state of a large quantum system in an experiment. "We cannot gain
complete knowledge about the system from a finite number of
measurements, but that is also not what we need," says Tim Langen, who
led the experiments in Schmiedmayer's research group. "With our new
method, we can reconstruct the quantum state from only a few
measurements. The precision is so high that we can use this approximate
state to predict the result of further measurements." This technique is
called "quantum tomography" -- much like computer tomography in a
hospital, where several pictures are used to calculate a 3D model,
quantum tomography uses several measurements to calculate a picture of
the quantum state.
The new method does not only open up new possibilities for many-body
quantum physics. It could also path the way to new quantum simulators --
quantum systems, which are prepared in such a way that they can be used
to simulate other quantum systems that cannot be controlled by standard
methods. "When two different quantum systems can be described with the
same basic formulas, then we can learn a lot about one system by
studying the other," says Schmiedmayer. "We can control thousands of
atoms on our quantum chip, this system is thus very well suited for
future quantum simulations."
Story Source:
The above post is reprinted from
materials provided by
Vienna University of Technology.
Note: Materials may be edited for content and length.